insulated building

    The combination of the THERMO roof and SANDWICH panel walling allows for the units to be used as workshops, production areas educational training, and any situation where people would be expected to work constantly within the building.

     

    Thermo Roof

    The THERMO Roof creates an insulation value of 1.6 W(m2K) thus allowing the units to have a better ambient temperature.

    The roof is a blown up roof which is inflated with a small, low power compressor unit. This creates an air pocket to give the insulation. The thermo roof is also useful for reducing noise and dramatically reduces the risk of condensation.

    The roofs are manufactured in a translucent white PVC material which is flame retardant to BS5438 part 2. The translucency allows for a high degree of natural light to be transmitted. Other colour roofs are available if required, however these do deduct the amount of light that is transmitted into the building and may increase heat build up.

    Sandwich Panel Walling

    As standard 40mm PIR insulated sandwich panels are utilised for a building requiring insulation. These panels offer a cost-effective insulation value of 0.46W/m2K.

    The panels have a standard finish in Goosewing Grey. Other colour options are available if required.
    60mm PIR insulated panel or a rockwool filled panel can be used for when fire ratings of 1 hour or more is stipulated.

    Non-Insulated Buildings

    A cost-effective building for weather protection. Utilising a single layer translucent white PVC material roof in conjunction with a corrugated steel sheet wall system. These units are ideal for storage of less sensitive goods. 

    Single Skin Roof

    The single skin roofs are manufactured in a translucent white PVC which is flame retardant to BS 5438 part 2. The translucency allows for a high degree of natural light to be transmitted. Other colour roofs are available if required, however these do deduct the amount of light that is transmitted into the building.
     

    Steel Sheet Walling

    Corrugated steel sheet walls offer a basic yet secure walling system. The system reflects the balance between cost and utilization. This walling is ideal for buildings that do not require any form of temperature control.
     

    Part Insulated Buildings

    A combination of roof & wall options.

    The part insulated building uses the THERMO roof system to protect against condensation and uses corrugated steel sheet walling where a temperature controlled enviroment is not necessay.

    Our Frame Section

    The frame is manufactured mainly using an aluminium T6 profile with any steel parts being hot dipped galvanised. Manufactured under ISO 9001: 2015 the frame is structurally compliant to BS6399 which is superseded by BS EN 1991 for UK wind & snow loads.

    WS Temporary Buildings are available in spans from 5m to 30m with a height to the eaves of 3.2m, 4.2m, 5.2m and 6.2m  The building frame works on a modular system which can be increased or decreased in length at any point, which allows you flexibility. Standard buildings are in 5m increments.